Samurai 4WD L4-1324cc 1.3L SOHC 5 Carb 8V (1986)
Fig. 5 Adjusting air gap
1.
Remove distributor cap and rotor.
2.
Using feeler gauge, measure air gap between signal rotor tooth and generator, Fig. 4. Air gap should be .008-.015 inch (.2-.4 mm).
3.
If gap is incorrect, remove igniter and loosen 2 screws holding generator.
4.
Using screwdriver, move generator to adjust gap to specification, Fig. 5.
5.
Tighten 2 screws and recheck air gap.
6.
Install igniter, rotor, and distributor cap.
