suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Power Steering Pump|Removal and Installation|Page 2471 > < Power Steering Fluid|Specifications
Page 1
background image

Power Steering Pump: Service and Repair
Removal and Installation

Before removing joints at inlet and outlet ports clean fitting thoroughly.
1. Disconnect battery ground cable, then the water reservoir tank from radiator.
2. On models with A/C, loosen A/C compressor adjusting bolt and pivot bolts.
3. On models less A/C, loosen power steering pump adjusting and mounting bolts.
4. Remove power steering belt.

Fig. 27  Discharge Connector Location

5. Remove union bolt. Hold discharge connector with wrench to prevent fluid from draining, Fig. 27.
6. Disconnect pump suction hose from oil tank, then the pump pressure switch lead wire at switch terminal.
7. Remove engine oil filter, then the pump adjusting and mounting bolts.
8. Remove power steering pump. Plug ports to prevent any foreign matter from entering.
9. Reverse procedure to install.

Power Steering Pump|Removal and Installation|Page 2471 > < Power Steering Fluid|Specifications