Sidekick 2WD L4-1590cc 1.6L SOHC 0 TBI 8V (1992)
Throttle Position Sensor: Service and Repair
REMOVAL
- Disconnect negative cable at battery.
- Disconnect TPS connector.
Removing Terminals
- Pull out TPS wire harness terminals from connector after unlocking terminal lock.
- Remove TPS from throttle body.
INSTALLATION
- Install TPS to throttle body.
Installing TPS
- Fit sensor to throttle body in such way that its adjusting holes are a little away from sensor mounting bolt holes as shown and turn sensor clockwise
so that those holes align. Then hand-tighten sensor mounting bolts in aligned holes.
Inserting Terminals
- Insert TPS terminals into connector and check to make sure that they are locked.
- Adjust installation angle of TPS.
- Connect battery negative cable to battery.
