Sidekick 2WD L4-1590cc 1.6L SOHC 0 TBI 8V (1992)
Transmission Position Switch/Sensor: Adjustments
Disconnecting Selector Cable
-
Place transmission in neutral
-
Hoist vehicle.
-
Remove locknut on end of cable and remove cable by moving shift lever to "L" range.
-
Set shift lever to "N" and loosen switch fastener bolt.
-
After turning shift lever clockwise fully, turn it counter clockwise until resistance is felt and tighten switch fastener.
-
Connect an ohm meter between BLACK/YELLOW and BLACK/RED wires in switch connector.
-
Check for continuity as follows by moving shift lever.
In PARK And NEUTRAL ..................................................................................................................................................................... Continuity
Other Than PARK And NEUTRAL ............................................................................................................................................... No Continuity
-
With selector lever (in car) held by an assistant, connect cable to shift lever while moving shift lever from "L" to "N".
NOTE: When another person's help is not available the following procedure can be used,
-
Remove center console box.
-
Shift lever to "N".
-
Insert a 4mm (0.16 in) rod into holes in selector lever position plate and selector lever.
This will hold lever in "N" position.
-
With both selector lever and in car selector in "N", install and tighten lock nut.
-
Lower vehicle and confirm proper selector operation.
-
Connect negative battery cable.
