Sidekick 2WD L4-1590cc 1.6L SOHC 0 TBI 8V (1992)
Emissions Maintenance Light: Service and Repair
Lamp Reset Switch
Federal Models
The Check Engine lamp will be illuminated when the ignition switch is in the On position with engine not operating. When engine is started, the
Check Engine lamp should go off. If lamp remains on, either a service interval is indicated or a code has been stored by the Electronic Control Module
(ECM) memory.
At mileage intervals of 50,000, 80,000 and 100,000 miles, the Check Engine lamp will be illuminated indicating required service and maintenance is
to be performed. After performing the required service, the lamp may be turned off by resetting the cancel switch located behind the L.H. side of the
instrument panel.
If a service code has been stored in the ECM memory, perform diagnosis and repair, then place ignition switch in Off position and clear codes stored
in the ECM memory by disconnecting the battery ground cable for approximately 20 seconds.
California Models
The Check Engine lamp will be illuminated when the ignition switch is in the On position with engine not operating. When engine is started, the
Check Engine lamp should go off. If lamp remains on, a code has been stored by the Electronic Control Module (ECM) memory. After diagnosis and
repair, place ignition switch in Off position, then clear codes stored in the ECM memory by disconnecting the battery ground cable, for approximately 20
seconds.
