Sidekick 2WD L4-1590cc 1.6L SOHC 0 TBI 8V (1992)
5. Fit circlip (1) around front bearing (2) and check to make sure that circlip just contacts with case surface.
6. Install bearing plate (1) applying thread lock cement to its bolts (2).
Tightening Torque (a) 6 Nm (48 inch lbs.)
7. Install reverse idle gear (1) together with needle bearing (2) and thrust washer (3) on shaft and fix them with bolt from outside of case.
Tightening Torque (b) 22 Nm (16.0 ft. lbs.)
NOTE: Be sure to use aluminum washer (4) for bolt.
8. Install reverse gear (5) and 5th gear (6) on counter shaft.
9. After press-fitting counter shaft rear bearing (1), with Special Tool (E) 09913-80112, make sure to fit circlip securely.
