Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
INSTALLATION
NOTE: Adjust clearance between booster piston rod and primary piston with special tool.
1. After moving brake booster a little as shown in figure, install master cylinder to brake booster.
2. Torque booster attaching nuts to (a): 13 Nm (9.5 ft. lbs.)
3. Torque master cylinder attaching nuts to (b): 13 Nm (9.5 ft. lbs.)
4. Connect hydraulic lines and torque flare nuts to (c): 16 Nm (12.0 ft. lbs.)
5. Connect reservoir lead wire.
6. Fill reservoir with specified brake fluid.
7. After installing, check brake pedal play and bleed air from system.
8. Perform brake test and check each installed part for fluid leakage.
