Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
4. Install crankshaft WITH OIL PUMP CHAIN to cylinder block.
5. Apply sealant "A" to lower crankcase mating surface area as shown in figure.
"A": Sealant 99000-31150 or equivalent.
6. Install lower crankcase to cylinder block. Apply oil to crankcase bolts before installing them. Tighten crankcase bolts, following sequence in
figure. Tighten crankcase bolts to specified torque.
Tightening Torque:
(a): 58 Nm (5.8 kg-m, 42.0 ft. lbs.)
(b): 27 Nm (2.7 kg-m, 19.5 ft. lbs.)
NOTE: After tightening crankcase bolts, check to be sure that crankshaft rotates smoothly when turned by hand.
7. Install rear oil seal by using plastic hammer and special tools.
Special Tools:
(A): 09911-97710 or equivalent.
