Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
Camshaft Position Sensor: Service and Repair
CAUTION:
Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.
REMOVAL
1) Disconnect CMP sensor coupler.
2) Remove CMP sensor by removing two bolts.
INSTALLATION
NOTE: After installing CMP sensor, adjust ignition timing.
1) Install a new 0-ring with engine oil applied to CMP sensor.
2) Install CMP sensor to camshaft.
Fit the dog of CMP sensor coupling into the slots of camshaft, when installing. The dogs of CMP sensor coupling are offset. Therefore, if the
dogs can not be fitted into the slots, turn the CMP sensor shaft by 180 degree and try again.
