Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
7. Remove circlip and pull off reverse hub from main shaft with puller and press, then take out synchronizer springs.
NOTE: It is also possible to remove reverse sleeve-hub as assembly and reverse gear all at once by using puller and press, after removing circlip.
8. Remove main shaft reverse gear and needle bearing by hand.
9. Using puller and press, remove reverse gear bush and bearing washer.
CAUTION: Do not attempt to pull out bearing, washer and bush all together at once. Steel ball would stop bearing and cause damage to it.
NOTE: During above work, watch out for steel ball which will come out from inside of washer so as not to lose it.
10. Pull off bearing with puller and press.
