Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
Tightening Torque (b) 9 Nm (78 inch lbs.)
11. If reverse gear shift limit bolt has been removed, apply thread lock cement "C" then install and torque it to specification.
Tightening Torque for limit bolt (c) 32 Nm (23.0 ft. lbs.)
12. Install gear shift lever case to transmission without using sealant for functional check.
13. Install shift control lever and check to make sure that it shifts smoothly according to shift pattern as shown in following figure.
Tightening Torque (d) 17 Nm (12.5 ft. lbs.)
NOTE:
-
Apply thread lock cement to control lever locating bolts when replaced.
-
Be sure to apply sealant to mating surface of gear shift lever for its final installation.
