suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Gear Shift Lever Case|Page 1900 > < Gear Shift Lever Case|Page 1898
Page 2
background image

3. Check gear shift shaft for excessive wear and correct or replace a necessary.

4. Check free length of each locating spring and replace if it is below service limit.

Free length "b":

Standard: 27.0 mm (1.063 inch) 
Service limit: 24.0 mm (0.945 inch) 

ASSEMBLY

Interlock system is as shown in the figure. Assemble its parts according to procedure as described.

1. With fork installed to reverse gear shift shaft, install it into case and put in interlock ball.

Gear Shift Lever Case|Page 1900 > < Gear Shift Lever Case|Page 1898