Sidekick 4WD L4-1590cc 1.6L SOHC 0 TBI 8V (1990)
2. Insert shift shaft as shown while making sure that inner parts are in proper direction.
NOTE:
-
Cut off in shift shaft should face downward when shift shaft is installed.
-
Use care for installing direction of shift limit spring.
-
Shift arm should be installed at the same time.
3. Drive in spring pin (single short) for reverse gear shift limit yoke.
4. Drive in spring pin (double) for shift lever.
5. Drive in spring pin (single long) for return spring.
6. Fit straight end of shift limit spring into line groove in shift limit yoke and with its other hooked end turned in its winding direction by about 90°
from its free state, hook it on spring pin.
7. Drive in spring pin for shift arm.
8. Press-fit case plug into case and caulk it with punch.
