Sidekick JS 2D 2WD L4-1.6L (1998)
INSPECTION PROCEDURE
FAILURE CONDITION:
DTC 15 can be set only before the Electronic Brake Control Module (EBCM) commands the relay on. This test determines if the Antilock Brake
System (ABS) enable relay is energized when it should not be. This malfunction would not allow the ABS enable relay to remove power to the ABS
system. If a second malfunction were to occur that requires the ABS enable relay to be turned off, that malfunction can not be removed if the relay can
not be controlled. The malfunction must be present for three consecutive drive cycles before the DTC is set.
DTC 16 - ABS Enable Relay Coil Circuit Open
