Sidekick JS 2D 2WD L4-1.6L (1998)
Drive Belt: Testing and Inspection
Water Pump
Water Pump Belt Inspection
INSPECTION
Inspect pump belt for wear or cracks, cuts, deformation and cleanliness. If it is necessary, replace belt.
Water Pump Belt Tension
WATER PUMP BELT TENSION
WARNING: Disconnect negative cable at battery before checking and adjusting belt tension.
1. Inspect belt for cracks, cuts, deformation, wear and cleanliness.
2. Check belt for tension. Belt is in proper tension when it deflects 6 to 8 mm (0.24-0.32 in.) under thumb pressure (about 10 kg or 22 lb.).
-
Belt tension "a": 6-8 mm (0.24-0.32 in.) as deflection/10 kg (22 lbs).
NOTE: When replacing belt with a new one, adjust belt tension to 5 - 7 mm (0.20-0.27 in.).
3. If belt is too tight or too loose, adjust it to proper tension by displacing generator position.
4. Tighten generator adjusting bolt and pivot bolts.
5. Connect negative cable at battery terminal.
