Sidekick JS 2D 2WD L4-1.6L (1998)
1. Install coil spring on spring seat of axle housing and then raise axle housing.
NOTE: When seating coil spring, mate spring end with stepped part of rear axle spring seat as shown.
2. Install shock absorber lower bolt. For its proper installing direction, refer to figure. Nut should not be tightened.
3. Connect cable hangers to trailing rod and chassis body. Remove floor jack from axle housing.
4. Install wheel and tighten wheel nuts to specified torque.
Tightening Torque (a): 95 Nm (69.0 ft. lbs.)
