Sidekick JS 2D 2WD L4-1.6L (1998)
6. Apply sealant to mating surface of bearing retainer with brake back plate.
NOTE: Make sure to remove old sealant before applying it anew.
"B": Sealant 99000-31110 or equivalent.
7. Install rear axle shaft to rear axle housing and tighten bearing retainer nuts to specified torque.
NOTE: When installing rear axle shaft, be careful not to cause damage to oil seal lip in axle housing.
Tightening Torque (a): 23 Nm (17.0 ft. lbs.)
8. Refill rear axle (differential) housing with new specified gear oil.
9. Install brake drum. Refer to Brakes and Traction Control.
