Sidekick JS 2D 2WD L4-1.6L (1998)
2. Aligning serrations between new stud bolt(s) and flange, install new stud bolt(s) by tightening nut as shown.
3. Install bearing retainer to shaft.
4. Press-fit wheel bearing and retainer ring as shown.
NOTE:
^
Use care not to cause any damage to outside of retainer ring.
^
Refer to figure so that wheel bearing is installed in proper direction.
5. Apply grease to axle shaft inner oil seal lip as shown.
"A": grease 99000-25010 or equivalent.
