Sidekick JS 2D 2WD L4-1.6L (1998)
Rear Door Window Glass: Service and Repair
Rear Door Glass Removal and Installation
Removal
1) Remove inside handle bezel fitting screw.
2) Remove door armrest or door inside pull handle case.
3) Remove window regulator handle (if equipped). To remove regulator handle, pull off snap ring by using a cloth as shown.
4) Remove door trim (1) with inside weatherstrip. With inside handle bezel (2) tilted as shown in the figure, turn door trim (1) 90— counterclockwise
to remove it. And disconnect power window switch lead wire (if equipped).
5) Remove door sealing cover.
6) Remove door outer weatherstrip.
CAUTION: Using a tape-wrapped putty knife (or tape-wrapped screwdriver), pry off weatherstrip. Use of an unwrapped tool will cause
damage to painting.
7) Remove glass fitting screws (2). Then down door glass (1).
3. Hole
8) Detach rear part of glass run (1) from center sash (2).