suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

2-Door Vehicle Without ABS|Page 2668 > < 2-Door Vehicle Without ABS|Page 2666
Page 1
background image

Load Compensator: Adjustments

Confirm the following before inspection and adjustment.

^

Fuel tank is fully filled.

^

Vehicle is equipped with spare tire, tools, jack and jack handle.

^

Vehicle is free from any other load.

1. Place it on level floor.
2. Push up LSPV lever with finger till it contacts stopper bolt and measure length of coil spring ("L" in figure) as it is pulled.
3. Spring length "L" should be 99 mm (3.897 inch.)

4. If out of specifications, adjust it by changing bolt (a) tightening positions as shown. After adjustment, tighten nut to (a): 23 Nm (17.0 ft. lbs.)

NOTE:  Check to make sure that LSPV body and brake pipe joints are free from fluid leakage. Replace defective parts, if any.

2-Door Vehicle Without ABS|Page 2668 > < 2-Door Vehicle Without ABS|Page 2666