Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
Removal
NOTE: Rear wheel speed sensor is serviceable only as an assembly.
1) Disconnect battery negative cable from battery and hoist vehicle.
2) Remove sensor cover.
3) Disconnect connector and remove sensor from differential carrier.
Installation
1) Before installation, check followings:
-
Check O ring for damage and deterioration. Replace if necessary.
-
Check to make sure that sensor tooth is free from any metal particles.
2) Install sensor to differential carrier. Apply sealant to sensor as shown and coat O ring with thin film of differential oil.
"A": Sealant 99000-31110
