Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
3-1) Turn ON ignition switch.
In this state, blow pipe "A".
Air should come out of pipe "C" and not out of pipe "B". If check results are as described above and E34-18 terminal to ECM connection is
OK, EGR solenoid vacuum valve (for system check) and its circuit are in good condition.
If not, proceed to step 4).
4) With ignition switch OFF, disconnect coupler from EGR solenoid vacuum valve (for system check).
5) Check resistance between two terminals of EGR solenoid vacuum valve (for system check)
Resistance of EGR solenoid vacuum valve (for system check): 37-44 Ohms at 20°C (68°F)
If resistance is as specified, proceed to step 6).
If not, replace.
6) Disconnect vacuum hoses from pipes.
7) Blow into pipe "A". Air should come out of pipe "B" and not out of pipe "C".
If not, replace EGR solenoid vacuum valve (for system check).