Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
Check contact coil and combination switch wire harness for any signs of scorching, melting or other damage.
If it is damaged, replace.
INSTALLATION
1. Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.
2. Install contact coil and combination switch assembly to steering column.
NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at its center position with a lock pin and
seal. Remove this lock pin after installing contact coil and combination switch assembly to steering column.
3. Connect contact coil and combination switch connectors and tighten its wire harness with band.
4. Install lower cover to key cylinder.
5. Tighten steering column lower cover screw.
NOTE: Marked with *are standard screw. The rest are tapping screws.
6. Install upper cover to lower cover.
7. Install knee bolster panel and hole cover.
