Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
2. Apply grease to pivot portions and seat, then install shift control lever.
3. If control lever locating bolts (1) are replaced or retightened, torque them as specified below.
Replacing of control lever locating bolts requires thread lock cement.
Tightening Torque (a) 17 Nm (12.5 ft. lbs.)
4. Install transmission boot No. 1 (1) from inside of cabin and clamp it with a new clamp (2) securely.
5. Tighten transmission boot No. 2 with boot cover (1) and console box bracket (2).
Tightening Torque (a) 6 Nm (48 inch lbs.)
6. Install console box leaving 2 mm (0.08 inch) from instrument panel (1) as shown.
Clearance "a": 2 mm (0.08 inch)
