Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
2. Turn special No. 09950-96010 tool upside down and place it on booster. Adjust booster piston rod length until rod end contacts pin head.
Clearance "b" is 0 mm (0 inch.)
3. Adjust clearance by turning adjusting screw of piston rod. Use special tool No. 09952-16010.
NOTE: When adjusted as above, its negative pressure is applied to the booster with the engine at idle, piston to piston rod clearance "a" should be as
follows:
Clearance "a" is as follows:
^
SE series 2-door vehicle without ABS is 0.25 - 0.5 mm (0.010 - 0.020 inch.)
^
Other SE series vehicles is 0.14 - 0.35 mm (0.006 - 0.014 inch.)
^
SZ series is 0.14 - 0.35 mm (0.OC6 - 0.014 inch.)
NOTE:
^ SE Series . . . . . . . .(tire size P195/75R 15)
^ SZ Series . . . . . . . .(tire size P195/75R 15)
