Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
(B): 09911-97810 or equivalent.
8. Install CKP sensor.
9. Install flywheel Manual Transmission (M/T vehicle) or drive plate Automatic Transmission (A/T vehicle). Using special tool, lock flywheel or
drive plate, and tighten flywheel or drive plate bolts applied with thread lock cement to specification.
"A": Thread lock 99000-32110 or equivalent.
Special Tool (A): 09924-17810 or equivalent.
Tightening Torque (a): 70 Nm (7.0 kg-m, 51.0 ft. lbs.)
10. Install engine side mounting brackets (right and left). Tighten bracket bolts to specified torque.
Tightening Torque (a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
11. Install water pump and heater outlet pipe.
12. Install pistons and connecting rods as previously outlined.
13. Install cylinder head assembly to cylinder block.
NOTE: Tighten cylinder head bolts to specified torque as previously outlined. Whenever installing cylinder head to new cylinder block, use
following procedure to tighten cylinder head bolts.
-
Tighten cylinder head bolts to specified torque as previously outlined and loosen them once till tightening torque becomes "zero." And then
torque them to specification again.
14. Install timing chains, timing chain tensioner, timing chain guide, timing chain sprockets, timing chain cover, crankshaft pulley, water pump pulley,
etc., as previously outlined.
15. Install oil pump strainer and oil pan.
16. Install clutch to flywheel (for M/T vehicle) or clutch installation.
17. Install engine assembly to vehicle as previously outlined.
