Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
2. Install oil pump strainer and oil pan. Install O rings in the position as shown in figure. With oil pump strainer inserted into oil pan, install strainer
to oil pump. Tighten strainer bolts first and then bracket bolt to specified torque.
Tightening Torque:
(a): 11 Nm (1.1 kg-m, 8.0 ft. lbs.).
(b): 11 Nm (1.1 kg-m, 8.0 ft. lbs.).
After fitting oil pan to cylinder block, run in securing bolts and start tightening at the center: move wrench outward, tightening one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening Torque (c): 11 Nm (1.1 kg-m, 8.0 ft. lbs.).
3. Install gasket and drain plug to oil pan. Tighten drain plug to specified torque.
Tightening Torque (a): 35 Nm (3.5 kg-m, 25.5 ft. lbs.).
4. Install clutch (torque converter) housing lower plate.
5. Install tie rod, center arm and idler arm.
6. Install front differential housing according to installation procedure.
7. Refill front differential housing with gear oil.
8. Install oil level gauge.
9. Refill engine with engine oil.
10. Check engine oil leakage.
11. Check wheel alignment
