Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
3) Using a service wire, connect E33-10 (E175-6) terminal of ECM coupler and body ground with ignition switch OFF.
3-1) Turn ON ignition switch.
In this state, blow hose "A".
Air should come out of hose "B".
WARNING: Do not suck the air through valve. Fuel vapor inside valve is harmful.
If check results are as described above and E33-1O (E17~6) terminal to ECM connection is in good condition, EVAP canister purge valve and its
circuit are in good condition, connect vacuum hoses securely.
If not, proceed to step 4).
4) With ignition switch OFF, disconnect coupler from EVAP canister purge valve.
5) Check resistance between two terminals of EVAP canister purge valve.
Resistance of EVAP canister purge valve:
28-36 Ohms at 20°C (68°F)
If resistance is as specified, proceed to next operation check. If not, replace.
6) Disconnect vacuum hoses from intake manifold and EVAP canister.
7) With coupler disconnected, blow into hose "A". Air should not come out of hose "B".
