Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
Power Steering Pump: Service and Repair
Removal and Installation
NOTE: Before removing joints at inlet and outlet ports of P/S pump, make sure to clean dirt thoroughly.
REMOVAL
1. Disconnect negative cable at battery.
2. Remove air cleaner outlet hose.
3. Remove generator belt.
4. Take out P/S fluid in oil tank with syringe or such.
5. Disconnect power steering pressure switch lead wire at switch terminal.
6. Disconnect P/S pump suction hose from P/S pump.
NOTE: As fluid flows out of disconnected hoses, put a plug to them or a cloth under them.
7. When removing union bolt, hold discharge connector with wrench or the like to prevent it from getting loose and drain P/S fluid.
8. Remove mounting bolts.
9. Remove P/S pump.
NOTE: Plug ports of removed pump to prevent dust and any foreign object from entering.
INSTALLATION
1. Install P/S pump by using mounting bolts.
Tightening Torque (a): 50 Nm (36.5 ft. lbs.)
