Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
9. By tapping knuckle on its end with hammer or using bearing puller, disconnect knuckle from ball stud.
10. While lowering jack, remove knuckle/wheel spindle comp.
11. Remove knuckle oil seal, dust cover and wheel spindle.
INSTALLATION
1. Check that no foreign material is attached to sensor and rotor.
2. Install it by reversing removal procedure.
Tightening Torque (a): 10 Nm (7.5 ft. lbs.)
CAUTION:
^
Do not pull wire harness or twist more than necessary when installing front wheel speed sensor.
^
Fit harness grommet to inner fender securely.
3. Check that there is no clearance between sensor and knuckle.
