Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
8. Remove strut bracket bolts.
9. Remove ball stud castle nut.
10. Remove knuckle and wheel hub comp, while lowering jack.
11. Remove coil spring and spring rubber seat.
INSTALLATION
Reverse removal procedure to install spring rubber seat and coil spring.
NOTE: Upper and lower diameters of coil spring are different.
^
Bring larger diameter end at bottom and set its open end in place on spring seat.
^
Be sure to use specified torque for tightening each fastener. Refer to torque specification chart at the end of this section.
^
As for tie-rod end castle nut, be sure to insert split pin and bend it after tightening it.
