Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
DISASSEMBLING ON FLANGE YOKE SIDE
Push out bearing race on flange yoke side as described in 1. and 2. above, and then, holding bearing race in a vise, tap flange yoke and take out race.
(Refer to the figure.)
Remove bearing race on the opposite side in the same way.
NOTE:
-
Take care not to lose rollers in spider bearing race when removing it.
-
Fit removed bearings temporarily in spider so that they can be reinstalled in their original positions.
ASSEMBLY
CAUTION: In reassembly, be sure to use new circlips, spider and bearings. Reuse of circlips, spider and bearings once reassembled is prohibited.
NOTE:
-
Make sure that rollers inside spider bearing race are all in place.
-
Make sure to apply Grease "A" to spider bearing race.