Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
7. Check to ensure that there is clearance between rear wheel bearing retainer and parking brake shoe lever. If no clearance is found, loosen cable
locking nut further to obtain clearance.
8. Using special tools (B) & (C) indicated below, draw out axle shaft.
NOTE: Use care not to pull brake back plate along with shaft.
Special Tool:
(C): 09943-35511
(B): 09942-15510 or equivalents.
9. Rear axle shaft that was drawn out.
Shaft length "L"
Left side: 683.5 mm (26.9 inch)
Right side: 726.5 mm (28.6 inch)
10. In order to remove sensor rotor from retainer ring, grind with a grinder one part of the sensor rotor as illustrated till it becomes thin.
