Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
8. Remove main shaft reverse gear and needle bearing by hand.
9. Using puller (3) and press, remove reverse gear bush (1) and bearing washer (2).
CAUTION: Do not attempt to pull out bearing, washer and bush all together at once. Steel ball would stop bearing and cause damage to it.
NOTE: During above work, watch out for steel ball which will come out from inside of washer so as not to lose it.
10. Pull off bearing (1) with puller and press.
11. Remove the following in that order: bearing washed steel ball, low gear, low synchronizer, needle bearing and low gear bush.
12. Using puller (1) and press, pull out low speed sleeve and hub assembly (2), 2nd gear (3) and 2nd synchronizer ring all together.
NOTE: If bush (4) can't be pulled out by hand at step 11, pull off sleeve and hub together by using press.
13. Remove sleeve from hub and then take off synchronizer keys and springs.
