Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
7. Fit sleeve (1) to reverse hub (2), place 3 synchronizer keys (3) in it and then set synchronizer springs (4). Refer to figure for proper installing
direction of hub, sleeve and springs. Also, note that key has specific installing direction.
8. Set steel ball and bearing washer (1) and insert reverse gear bush (2), needle bearing (3) and reverse gear (4).
9. Press-fit reverse sleeve and hub assembly (1) with special tools and press.
Special Tools:
(B) 09925-18010
(C) 09927-08210
(D) 09940-53111
10. After setting large circlip (1), install 5th speed synchronizer ring, needle bearing, 5th gear (2), steel ball (3) and washer (4).
NOTE: Washer should be installed with its oil slot side facing gear.
