Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
RESISTANCE CHECK
1) Disconnect ECM couplers from ECM with ignition switch OFF.
CAUTION: Never touch terminals of ECM itself or connect voltmeter or ohmmeter.
2) Check resistance between each pair of terminals of disconnected couplers as listed in following table.
CAUTION:
-
Be sure to connect ohmmeter probe from wire harness side of coupler.
-
Be sure to turn OFF ignition switch for this check.
-
Resistance in table represents that when parts temperature is 20°C (68°F).
