Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator Removal and Installation
Removal
1) Remove door glass referring to Rear Door Glass Removal and Installation.
2) Disconnect power window motor lead wire at coupler and clamp.
3) Remove door window regulator attaching screws (6 pcs.) (1), and take out regulator through hole "A" as shown in the figure.
Installation
Reverse removal sequence to install door window regulator noting the following points.
-
Adjust door window regulator according to the following procedure.
a. Loosen 5 screws and 2 bolt as shown in the figure.
b. Raise window fully with regulator handle.
c. Tighten 3 screws (1) and 2 bolts (1).
d. Lower window.
e. Tighten 2 screws (2).
-
Securely seal door sealing cover (1) with adhesive (2).
