Sidekick JX 2D 4WD L4-1.6L (1998)
14. Remove coil spring.
INSTALLATION
Reverse removal procedure to install coil spring.
NOTE:
^
Upper and lower diameters of coil spring are different.
^
Bring larger diameter end at bottom and set its open end in place on spring seat.
1. Be sure to use specified torque for tightening each fastener.
2. Refer to torque specification chart at the end of this section.
3. As for tie-rod end castle nut and ball stud nut, be sure to insert split pin and bend it after tightening it.
4. Apply lithium grease to front axle shaft washer.
"A": Grease 99000-25010 or equivalent.
5. When installing circlip to drive shaft, utilize screw hole in drive shaft to pull it out and bring large diameter of circlip at right as shown.
