Sidekick JX 2D 4WD L4-1.6L (1998)
Clutch Cable: Service and Repair
CLUTCH CABLE
REMOVAL
1. Disconnect negative cable at battery.
2. Remove clutch cable joint nut (1).
3. Loosen outer cable nuts (2) then disconnect cable from bracket and release arm (3).
4. Untie cable clamps.
5. Remove clutch cable outer bolts at dash panel in engine room.
6. Disconnect cable hook at clutch pedal shaft arm (4), then take off cable.
INSPECTION
Inspect clutch cable and replace it for any of following conditions.
-
Excessive cable friction.
-
Frayed cable.
-
Bent or kinked cable.
-
Broken boots.
-
Worn end.
INSTALLATION
1. Apply grease to cable end hook and also joint pin before installing cable.
"A": Grease 99000-25010
2. Position cable and hook cable end with clutch pedal shaft arm.
