Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
new crankshaft or alphabets stamped on mating surface of new cylinder block.
^
Undersize Bearing (0.25 mm): 0.25 mm undersize bearing is available, in five kinds varying in thickness. To distinguish them, each bearing is
painted in following colors at such position as indicated in figure. Each color represents following thicknesses at the center of bearing.
Color Painted: Green and Red
Bearing Thickness: 2.121 - 2.125 mm (0.0835 - 0.0836 inch)
Color Painted: Black and Red
Bearing Thickness: 2.124- 2.128 mm (0.0836 - 0.0837 inch)
Color Painted: Red only
Bearing Thickness: 2.127-2.131 mm (0.0837 - 0.0838 inch)
Color Painted: Yellow and Red
Bearing Thickness: 2.130 - 2.134 mm (0.0838 - 0.0839 inch)
Color Painted: Blue and Red
Bearing Thickness: 2.133 - 2.137 mm (0.0839 - 0.0840 inch)
^
If necessary, regrind crankshaft journal and select under size bearing to use with it as follows.
1. Regrind journal to following finished diameter.
Finished Diameter: 51.732 - 51.750 mm (2.0367 - 2.0373 inch)
2. Using micrometer, measure reground journal diameter. Measurement should be taken in two directions perpendicular to each other in order
to check for out -of-round.
3. Using journal diameter measured above and alphabets stamped on mating surface of cylinder block, select an undersize bearing by
referring to table given below. Check bearing clearance with newly selected undersize bearing.
Measured Journal Diameter: 51.744- 51.750 mm (2.0371 - 2.0373 inch)
Alphabets Stamped On Mating Surface Of Cylinder Block:
A (Green and Red)
B (Black and Red)
C (Red only)
Measured Journal Diameter: 51.738 - 51.744 mm (2.0369 - 2.0371 inch)
A (Black and Red)
B (Red only)
C (Yellow and Red)
Measured Journal Diameter: 51.732 - 51.738 mm (2.0367 - 2.0369 inch)
A (Red only )
B (Yellow and Red)
C (Blue and Red)
Undersize bearing to be installed.
REAR OIL SEAL
