Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
Power Steering Pump: Service and Repair
Removal and Installation
NOTE: Before removing joints at inlet and outlet ports of P/S pump, make sure to clean dirt thoroughly.
REMOVAL
1. Disconnect battery negative cable.
2. Disconnect coolant reservoir tank from radiator.
3. Loosen air conditioning compressor adjusting bolt and pivot bolts (if equipped with A/C). Loosen P/S pump adjusting bolt and mounting bolt (if
not equipped with A/ C).
4. Remove power steering belt.
5. When removing union bolt, hold discharge connector with wrench or the like to prevent it from getting loose end drain P/S fluid.
6. Disconnect P/S pump suction hose from oil tank.
7. Disconnect Power steering pressure switch lead wire at switch terminal.
8. Remove engine oil filter.
9. Remove P/S pump adjusting bolt and mounting bolt.
10. Remove P/S pump.
NOTE: Plug ports of removed pump to prevent dust and any foreign object from entering.
INSTALLATION
