Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
11. Remove stud bolt(s) by using hydraulic press.
INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following.
1. To install bearing retainer oil seal, be sure to apply small amount of grease to its periphery and press-fit it by using special tools (A & B). Be
careful to press-fit in proper direction, to proper extent and evenly. For its proper installing direction and extent, refer to figure.
Apply grease to oil seal lip as shown and install it to axle shaft.
Special Tool:
(A): 09924-74510
(B): 09926-88310
"A": Grease 99000-25010 or equivalents.
2. Aligning serrations between new stud bolt(s) and flange, install new stud bolt(s) by tightening nut as shown.
