Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
5. Fit circlip around bearing and check to make sure that circlip just contacts with case surface.
6. Install bearing plate applying thread lock cement to its bolts (a).
Tightening Torque (a) 6 Nm (48 inch lbs.)
7. Install reverse idle gear together with needle bearing and thrust washer on shaft and fix them with bolt from outside of case.
Tightening Torque (b) 22 Nm (16.0 ft. lbs.)
NOTE: Be sure to use aluminum washer for bolt.
8. Install reverse gear and 5th gear on counter shaft.
