Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
4. If control lever locating bolts (a) are replaced or retightened, torque them as specified below.
Replacing of control lever locating bolts requires thread lock cement.
Tightening Torque (a) 17 Nm (12.5 ft. lbs.)
5. Install transmission boot No. 1 from inside of cabin and clamp it with a new clamp securely.
6. Install transfer boot No. 1 securely on lift and clamp it by using a new clamp.
7. Tighten transmission boot No. 2 with boot cover and console box bracket.
Tightening Torque (b) 6 Nm (48 inch lbs.)
