Sidekick Sport 2D JX 4WD L4-1.8L (1998)
1. Make sure that O-ring and case have not been damaged.
2. Apply grease to lip portion of new oil seal and install it until bottom. Special tool (A) may be used for installation.
"A": Grease 99000-25010
Special Tool
(A): 09916-46010
3. Inspect speedometer driven gear for abnormal wear of gear teeth or bend of shaft portion and replace it if necessary.
4. Insert driven gear to case and fix spring pin (type-1 only), then make sure its smooth rotation.
5. Install case assembly to transfer and connect cable as it was.
Tightening Torque
(a): 10 Nm (1.0 kg-m, 7.5 ft. lbs.)
6. Make sure oil level is in specification.
With Overdrive
SPEEDOMETER DRIVEN GEAR
(2WD)
REMOVAL
1. Lift up vehicle horizontally or rear up.
2. Disconnect speedometer cable at extension case.
3. Remove driven gear bolt and plate.
4. Take off driven gear and from extension case.
INSTALLATION
