Swift L4-1298cc 1.3L SOHC MFI (1997)
4. Remove motor pack from ABS actuator.
CAUTION:
^
Use care when handling motor pack to ensure motor pack connector is not damaged, or accidental intrusion of brake fluid into the motor pack
does not occur. This may result in a premature failure of the motor pack.
^
Take care in handling the motor pack. If dropped or damaged during handling, the motor pack must be replaced.
^
No repair of the motor pack is authorized. Replace as an assembly
NOTE:
^
If disassembly of the ABS actuator assembly was due to a ABS hydraulic functional test that did not pass, the "Automated Motor Pack
Diagnosis Test" should be performed at this time to isolate the motor pack or ABS actuator. See: Testing and Inspection
INSTALLATION
1. Install motor pack to ABS actuator.
2. Tighten bolts to (b): 4.5 Nm (42 inch. lbs.).
2. Install under cover
2. Tighten bolts to (a): 4 Nm (36 inch. lbs.).
NOTE:
^
With the ABS actuator upside down, and the gears facing you, rotate each ABS actuator gear counterclockwise until movement stops. This
procedure will position the pistons very close to the top of the modulator bore, simplifying the brake bleeding procedure.
