Swift L4-1298cc 1.3L SOHC MFI (1997)
ABS Actuator Assembly: Service and Repair
Flow Control Solenoid
REMOVAL
1. Disconnect battery negative cable from battery.
2. Disconnect solenoid harness coupler.
3. Remove solenoid(s).
NOTE: Be sure that the seal is still attached to the solenoid when it is removed. If not, check the solenoid bore in the ABS actuator.
INSTALLATION
1. Install solenoid to ABS actuator.
NOTE:
^
Lubricate seal on solenoid with clean brake fluid.
^
Verify that the solenoid lip seal is properly positioned before solenoid is installed into the ABS actuator.
^
Position solenoid so that its electrical connector will face the same direction prior to removal.
^
By hand, press down firmly on the solenoid until its flange seats onto the ABS actuator.
2. Tighten solenoid mounting bolts to a torque of (b): 4.5 Nm (3.5 ft. lbs.).
3. Connect solenoid harness coupler.
