Swift L4-1298cc 1.3L SOHC MFI (1997)
4. When fluid pressure-in the cylinder is almost depleted, re-tighten bleeder plug (a).
5. Repeat this operation 3 and 4 until there are no more air bubbles in hydraulic line.
6. When bubbles stop, depress and hold brake pedal and tighten bleeder plug (a): to a torque of 9 - 13 Nm (7.9 - 9.0 ft. lbs.).
7. Repeat steps 1 through 6 for bleeder plug (B).
8. Bleed from brake calipers/wheel cylinders as shown procedure below.
NOTE: Perform bleeding operation starting with wheel cylinder farthest from master cylinder and then at front caliper of the same brake line. Do
the same on the other brake line.
a. Fill master cylinder reservoir with brake fluid and keep at least one-half full of fluid during bleeding operation.
b. Remove bleeder plug cap. Attach a vinyl tube to bleeder plug, and insert the other end into container.
