Swift L4-1298cc 1.3L SOHC MFI (1997)
Standard: 17 mm (0.67 in.)
Limit: 11.5 mm (0.45 in.)
INSPECT BRUSH HOLDER AND SPRING
Check movement of brush in brush holder.If brush movement within brush holder is sluggish,check brush holder for distortion and sliding faces for
contamination.Clean or correct as necessary.
Check for continuity across insulated brush holder (positive side) and grounded brush holder (negative side).
If continuity exists,brush holder is grounded due to defective insulation and should be replaced.
Inspect brush spring for wear,damage or other abnormal conditions.
Replace if necessary.
Brush spring tension
Standard: 1.95 kg (4.3 lb.)
Limit : 0.9 kg (1.98 lb.)
INSPECT DRIVE LEVER
Inspect drive lever for wear. Replace if necessary.
INSPECT PINION
Inspect pinion for wear,damage or other abnormal conditions. Check that clutch locks up when turned in direction of drive and rotates smoothly in
reverse direction. Replace if necessary.