Swift L4-1298cc 1.3L SOHC MFI (1997)
Clutch Cable: Service and Repair
REMOVAL
1. Remove clutch cable joint nut and disconnect joint pin from inner cable.
2. Remove 2 bolts at dash panel, unhook cable end from pedal top by using screwdriver from engine room, and then take out cable.
INSPECTION
Inspect clutch cable and replace it if any of following conditions exists.
-
Excessive cable friction.
-
Frayed cable.
-
Bent or kinked cable.
-
Broken boots.
-
Worn end.
INSTALLATION
1. Apply grease to cable end hook and also joint pin before installing cable.
2. Hook cable end with pedal by using screwdriver or long nose pliers from cabin inside, then join inner cable with joint pin in release arm.
3. Apply water tight sealant to mating surface of cable and fasten it with 2 bolts to dash panel.
"A": Sealant
Tightening Torque (a): 4 - 7 Nm (36 - 60 inch lbs.)
4. Screw in joint nut and adjust free travel of pedal to specification by turning nut.
5. Check clutch for proper function with engine running.
